• To enable L2PT for all supported protocols:[edit]user@switch# set vlans customer-1 dot1q-tunneling layer2-protocol-tunneling all3. (Optional) Configure the drop threshold:NOTE: If you also configure the shutdown threshold, ensure that youconfigure the drop threshold value to be less than or equal to the shutdownthreshold value. If the drop threshold value is greater than the shutdownthreshold value and you to try to commit the configuration changes, thecommit will fail.[edit]user@switch# set vlans customer-1 dot1q-tunneling layer2–protocol-tunneling stpdrop-threshold 504. (Optional) Configure the shutdown threshold:NOTE: If you also configure the drop threshold, ensure that you configurethe shutdown threshold value to be greater than or equal to the dropthreshold value. If the shutdown threshold value is less than the dropthreshold value and you to try to commit the configuration changes, thecommit will fail.[edit]user@switch# set vlans customer-1 dot1q-tunneling layer2–protocol-tunneling stpshutdown-threshold 100NOTE: Once an interface is disabled, you must explicitly reenable it usingthe clear ethernet-switching layer2-protocol-tunneling error command.Otherwise, the interface remains disabled.RelatedDocumentationExample: Configuring Layer 2 Protocol Tunneling on J-EX Series Switches on page 1126•• Understanding Layer 2 Protocol Tunneling on J-EX Series Switches on page 1056Configuring MAC Notification (CLI Procedure)When a switch learns or unlearns a MAC address, SNMP notifications can be sent to thenetwork management system at regular intervals to record the addition or removal ofthe MAC address. This process is known as MAC notification.The MAC notification interval defines how often Simple Network Management Protocol(SNMP) notifications logging the addition or removal of MAC addresses on the switchare sent to the network management system.1151Chapter 59: Configuring Bridging and VLANs
