CHAPTER 52Configuring Interfaces• Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 909• Port Role Configuration with the J-Web Interface (with CLI References) on page 915• Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 919• Setting the Mode on an SFP+ Uplink Module (CLI Procedure) on page 921• Configuring Aggregated Ethernet Interfaces (CLI Procedure) on page 922• Configuring Aggregated Ethernet Interfaces (J-Web Procedure) on page 923• Configuring Aggregated Ethernet LACP (CLI Procedure) on page 926• Configuring Unicast RPF (CLI Procedure) on page 927• Disabling Unicast RPF (CLI Procedure) on page 928• Configuring IP Directed Broadcast (CLI Procedure) on page 929• Configuring a Layer 3 Subinterface (CLI Procedure) on page 930Configuring Gigabit Ethernet Interfaces (J-Web Procedure)An Ethernet interface must be configured for optimal performance in a high-trafficnetwork.To configure properties on a Gigabit Ethernet interface or a 10-Gigabit Ethernet interfaceon a J-EX Series switch:1. Select Interfaces > Ports.The page lists Gigabit Ethernet and 10-Gigabit Ethernet interfaces and their link status.NOTE: After you make changes to the configuration in this page, you mustcommit the changes immediately for them to take effect. To commit allchanges to the active configuration, select Commit Options > Commit. See“Using the Commit Options to Commit Configuration Changes (J-WebProcedure)” on page 334 for details about all commit options.2. Select the interface you want to configure. If the interface you want to configure isnot listed under Ports in the top table on the page, select the FPC (the FPC is the line909
