292 | Creating, Running, and Emailing Reports Dell PowerConnect W AirWave 7.1 | User GuideEmailing and Exporting ReportsThis section describes three ways in which distribute reports from AWMS: Emailing Reports in General Email Applications Emailing Reports to Smarthost Exporting Reports to XML or CSVEmailing Reports in General Email ApplicationsPerform these steps to set up email distribution of reports in AWMS: All reports contain a link to export the report to an XML file and a text box where you may specify emailaddresses, separated by commas, to which reports are sent. Click Email This Report to email the report to the address specified in the text box above the button.Additional information about email-based report generation is described in “Defining Reports” on page 289, andin “Emailing Reports to Smarthost” on page 292.Emailing Reports to SmarthostAWMS uses Postfix to deliver alerts and reports via email, because it provides a high level of security and locallyqueues email until delivery. If AWMS sits behind a firewall, which prevents it from sending email directly to thespecified recipient, use the following procedure to forward email to a smarthost.1. Add the following line to /etc/postfix/main.cf:relayhost = [mail.Aruba.com]Where: mail.Aruba.com is the IP address or hostname of your smarthost.2. Run service postfix restart3. Send a test message to an email address.Mail -v xxx@xxx.comSubject: test mail.CC:4. Press Enter.5. Check the mail log to ensure mail was sentUsing the PortUsage ReportYes Yes Summarizes switch and port information across thenetwork. Generates information on the unused ports.Provides a detailed list of all available switches and ports inthe network.Using the RADIUSAuthenticationIssues ReportYes Yes Summarizes RADIUS authentication issues by controllerand by user, as well as a list of all issues.Using the RogueContainment AuditReportNo Yes Identifies discrepancies between access pointcontainment status specified in AMP compared tocontainment status identified by the controller at report runtime.Using the UserSession ReportYes Yes Summarizes user data by radio mode, SSID and VLAN, aswell as lists all sessions.Table 143 Report Types and Scheduling Options Supported for Custom Reports (Continued)Report Type Can by Run byTime PeriodCan be Run byGroup/Folder Description
