Dell PowerConnect W AirWave 7.1 | User Guide Configuring and Using Device Groups in AWMS | 8914. To configure Symbol or Intel-specific settings, locate the Symbol/Intel section and adjust these settings asrequired. Table 48 describes the settings and default values of this section.15. To configure settings specific to Dell PowerConnect W, locate the Dell PowerConnect W section and adjustthese settings as required. Table 49 describes the settings and default values of this section.SNMP Version 2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to theAP.Table 47 HP ProCurve 420 Fields and Default ValuesSetting Default DescriptionNote: DST Start Month, Start Day, End Month and End Day are only visible if Daylight Saving Time is enabled in the NTP section ofthe Groups > Basic configuration page.Table 48 Symbol/Intel Fields and Default ValuesSetting Default DescriptionSNMP Version 2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to thedevice.Symbol/Intel ClientInactivity Timeout(3-600 min)3 Sets the minutes of inactivity after which a client associated to an Intel or Symbol AP willbe considered "inactive." A lower value typically provides a more accurate representationof current WLAN usage.NOTE: For other APs, AWMS has more precise methods to determine when inactive clientsare no longer associated to an AP.Symbol ControllerCLI CommunicationTelnet Select which connection type is to support the command-line interface (CLI) connection.The options are Telnet and secure shell (SSH). This is supported for WS5100 and RFS7000devices only.Web ConfigInterfaceYes Enables or disables the http/https configuration page for the Symbol 4131 and Intel 2011devices.Table 49 Dell PowerConnect W Fields and Default ValuesSetting Default DescriptionSNMP Version 2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to the AP.Offload DellPowerConnect WWMS databaseNo Configures commands previously documented in the Dell PowerConnect W AirWave BestPractices Guide. See the current Best Practices guide for more information about thisfeature. When enabled, this feature allows AWMS to display historical information for WLANswitches.Changing the setting to Yes pushes commands via SSH to all WLAN switches in Monitor Onlymode without rebooting the controller. The command can be pushed to controllers in managemode (also without rebooting the controller) if the Allow WMS Offload setting on the AWMSconfiguration page is changed to Yes.Dell PowerConnectW GUI ConfigYes Enables or disables AWMS support for the Dell PowerConnect W configuration interface.This setting relates to the Device Setup > Dell PowerConnect W Configuration page and allrelated operations. For additional information, refer to the Dell PowerConnect WConfiguration Guide.
