96 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide5. Locate the Encryption area on the Groups > SSIDs page and adjust these settings as required. Table 56describes the settings and default values.6. Locate the EAP Options area on the Groups > SSIDS page, and complete the settings.Table 57 describes the settings and default values.Name None Sets a user-definable name associated with SSID/VLAN combination.VLAN ID None Indicates the number of the VLAN designated as the Native VLAN, typically formanagement purposesService Priority(Cisco VxWorks only)None Identifies the delivery priority which packets receive on the VLAN/SSID(VxWorks only).Maximum AllowedAssociations (0-2007)255 Indicates the maximum number of mobile users which can associate with thespecified VLAN/SSID.NOTE: 0 means unlimited for Cisco and none for Colubris.Broadcast SSID (Proximonly)No For specific devices as cited, this setting enables the AP to broadcast theSSID for the specified VLAN/SSID. This setting works in conjunction with theCreate Closed Network setting on the Groups> Security configuration page.Proxim devices support a maximum of four SSIDs.NOTE: This option should be enabled to ensure support of legacy users.Partial Closed System(Proxim only)No For Proxim only, this setting enables to AP to send its SSID in every beacon,but it does not respond to any probe requests.Unique Beacon(Proxim only)No For Proxim only, if more than one SSID is enabled, this option enables them tobe sent in separate beacons.Block All Inter-clientCommunicationYes For Colubris only, this setting blocks communication between client devicesbased on SSID.Table 56 Groups > SSIDs > Encryption Section Fields and Default ValuesSetting Default DescriptionEncryption Mode No Encryption Drop-down menu determines the level of encryption required for devices to associateto the APs. The drop-down menu options are as follows. Each option displaysadditional encryption settings that must be defined. Complete the associated settingsfor any encryption type chosen: Optional WEP—Wired Equivalent Privacy, not PCI compliant as of 2010 Require WEP—Wired Equivalent Privacy, not PCI compliant as of 2010 Require 802.1x—This encryption type is based on the WEP algorithm. Require Leap—Lightweight Extensible Authentication Protocol 802.1x+WEP—Combines the two encryption types shown LEAP+WEP—Combines the two encryption types shown Static CKIP—Cisco Key Integrity Protocol WPA—Wi-Fi Protected Access protocol WPA/PSK—Combines WPA with Pre-Shared Key encryption WPA2—Wi-Fi Protected Access 2 encryption WPA2/PSK—Combines the two encryption methods shownTable 55 Groups > SSIDs > SSID/VLAN Section Fields and Default Values (Continued)Setting Default Description
