PowerConnect W-AirWave. The Settings window appears with Admin tab selected. Forinformation to configure Dell PowerConnect W-AirWave, see "Configuring Dell PowerConnectW-AirWave" on page 207.Figure 29 - Dell PowerConnect W-AirWave Setup Link – Dell PowerConnect W-AirWaveConfigurationPause/ResumeThe Pause/Resume link is located at the bottom right corner of the Dell W-Series Instant UI. TheDell W-Series Instant UI is automatically refreshed after every 15 seconds by default.Click the Pause link to pause the automatic refreshing of the Dell W-Series Instant UI. When theautomatic Dell W-Series Instant UI refreshing is paused, the Pause link changes to Resume. Clickthe Resume link to resume automatic refreshing.The Pause link is useful when you want to analyze or monitor the network or a network elementand therefore do not want the user interface to refresh. Automatic refreshing allows you to get thelatest information about the network and network elements.ViewsDepending on the link or tab that is clicked, the Dell W-Series Instant UI displays informationabout the Virtual Controller, Wi-Fi networks, W-IAPs, or the clients in the Info section. Theviews on the Dell W-Series Instant UI are classified as follows:l Virtual Controller view— The Virtual Controller view is the default view. This view allows youto monitor the Dell W-Instant network.l Network view— The Network view provides information that is necessary to monitor a selectedwireless network. All Wi-Fi networks in the Dell W-Instant network are listed in the Networkstab. Click the name of the network that you want to monitor. Network view for the selectednetwork appears.l W-Instant Access Point view— The W-Instant Access Point view provides information that isnecessary to monitor a selected W-IAP. All W-IAPs in the Dell W-Instant network are listed inthe Access Points tab. Click the name of the W-IAP that you want to monitor. Access Pointview for that W-IAP appears.l Client view— The Client view provides information that is necessary to monitor a selectedclient. In the Client view, all the clients in the Dell W-Instant network are listed in theDell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide 41 | Dell W-Instant User Interface
