Automatic Firmware Image Check and UpgradeAutomatic image check is enabled by default. If Dell PowerConnect W-AirWave is configured,then the automatic image check is automatically disabled, use the manual image check option tocheck for the latest image. For more information, see "Upgrading to New Version" on page 88 and"Configuring Dell PowerConnect W-AirWave" on page 207 for steps on how to configure DellPowerConnect W-AirWave.If the Automatic image check is enabled, then the following actions take place:l once after every time the AP boots upl once every week thereafterIf the image check locates a new version of the W-Instant software on the image server, then aNew version available link appears at the top right corner of the Dell W-Series Instant UI.Figure 63 - Automatic Image Check — New Version Available LinkAfter the Automatic image check feature identifies a new version, perform the following steps toupgrade to the new version:1. The Maintenance window appears. Click Upgrade Now to upgrade the W-IAP to the newerversion.Figure 64 - New Version AvailableAfter you confirm, the AP downloads the new software image from the server, saves it to flash, andreboots. Depending on the progress and success of the upgrade, one of the following messages isdisplayed:Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide 87 | Managing W-IAPs
