Setting DescriptioniDRAC IPv6 Gateway Specifies the default IPv6 gateway to be assigned to theiDRACs. The default value is "::".iDRAC IPv6 Prefix Length Specifies the prefix length to be assigned for the IPv6addresses on the iDRAC. The default value is 64.Use CMC DNS Settings Enables the CMC DNS Server settings ( IPv4 and IPv6) thatare propagated to iDRAC when a blade server is inserted inthe chassis.3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC network setting, click ApplyiDRAC Network Settings to deploy the settings to the iDRAC.The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis.To copy the QuickDeploy settings into the iDRAC Network Settings section, click Auto-Populate Using QuickDeploySettings. The QuickDeploy network configurations settings are copied into the corresponding fields in the iDRAC NetworkConfiguration Settings table.NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more iDRAC servernetwork configuration settings may require a couple of minutes to propagate from CMC to iDRAC. Clicking Refreshearly may display only partially correct data for one or more iDRAC servers.QuickDeploy IP address assignments for serversThe following tables show the way that the QuickDeploy IP addresses assigned to the servers based on the sleds present in theFX2/FX2s Chassis:• Two full-width sleds in the chassis:• Four half-width sleds in the chassis:• Eight quarter-width sleds in the chassis:NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.• Four FM120x4 sleds in the chassis:NOTE: The Reserved QuickDeploy IPAddresses must be set to 16.• Top row contains only quarter-width sleds and bottom row contains only half-width sleds:NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.76
