NOTE: The iDRAC VLAN settings from CMC are effective only when iDRAC NIC selection is set on the iDRAC forChassis (dedicated) LOM mode.Configuring iDRAC VLAN tag settings using web interfaceTo configure VLAN for server:1. Go to any of the following pages:• In the left pane, click Chassis Overview → Network → VLAN.• In the left pane, click Chassis Overview → Server Overview and click Setup → VLAN.2. On the VLAN Tag Settings page, in the iDRAC section, enable VLAN for the servers, set the priority and enter the ID. Formore information about the fields, see the CMC for Dell PowerEdge FX2/FX2s Online Help.3. Click Apply to save the settings.Configuring iDRAC VLAN tag settings using RACADM• Specify the VLAN ID and priority of a particular server with the following command:racadm setniccfg -m server-<n> -v <VLAN id> <VLAN priority>The valid values for <n> are 1–4.The valid values for <VLAN> are 1–4000 and 4021–4094. Default is 1.The valid values for <VLAN priority> are 0–7. Default is 0.For example:racadm setniccfg -m server-1 -v 1 7For example:• To remove a server VLAN, disable the VLAN capabilities of the specified server's network:racadm setniccfg -m server-<n> -vThe valid values for <n> are 1–16.For example:racadm setniccfg -m server-1 -vSetting first boot deviceYou can specify the CMC first boot device for each server. This may not be the actual first boot device for the server, or may noteven represent a device present in that server. It represents a device sent by CMC to the server and used as its first boot device ofthat server. This device can be set as the default first-boot device or an one-time device so that you can boot an image to performtasks such as running diagnostics or reinstalling an operating system.You can set the first boot device for the next boot only or for all subsequent reboots. You can also set the first boot device for theserver. The system boots from the selected device on the next and subsequent reboots and remains as the first boot device in theBIOS boot order, until it is changed again either from the CMC web interface or from the BIOS boot sequence.NOTE: The first boot device setting in CMC web Interface overrides the system BIOS boot settings.The boot device that you specify must exist and contain a bootable media.You can set the following devices for first boot. However, to set a device as a default first-boot device, select Default.To not to override the server firmware version if the firmware version running on the server is same as the version available in thefirst boot device, select None.You can set the following devices for first boot.78
