• Top row contains only full-width sleds and bottom row contains only half-width sleds:• Top row contains full-width sleds and bottom row contains only quarter-width sleds:NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.Modifying iDRAC Network Settings for individual server iDRACUsing this feature, you can configure the iDRAC network configurations settings for each installed server. The initial values displayedfor each of the fields are the current values read from the iDRAC. To use this feature, you must have an Enterprise License.To modify the iDRAC Network Settings:1. In the left pane, click Server Overview, and then click Setup. On the Deploy iDRAC page the iDRAC Network Settingssection lists the iDRAC IPv4 and IPv6 network configuration settings of all the installed servers.2. Modify the iDRAC network settings as required for the servers.NOTE: You must select the Enable LAN option to specify the IPv4 or IPv6 settings. For information about the fields,see theCMC for Dell PowerEdge FX2/FX2s Online Help.3. To deploy the setting to iDRAC, click Apply iDRAC Network Settings. Any changes made to the QuickDeploy Settings arealso saved.The iDRAC Network Settings table reflects future network configuration settings; the values shown for installed servers mayor may not be the same as the currently installed iDRAC network configuration settings. Click Refresh to update the iDRACDeploy page with each installed iDRAC network configuration settings after changes are made.NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more iDRAC servernetwork configuration settings may require a couple of minutes to propagate from CMC to iDRAC. Clicking Refreshtoo soon may display only partially correct data for a one or more iDRAC servers.Modifying iDRAC network settings using RACADMRACADM config or getconfig commands support the -m option for the following configuration groups:• cfgLanNetworking• cfgIPv6LanNetworking• cfgRacTuning• cfgRemoteHosts• cfgSerial• cfgSessionManagementFor more information about the property default values and ranges, see the Dell Integrated Dell Remote Access Controller (iDRAC)RACADM Command Line Reference Guide and Chassis Management Controller for PowerEdge FX2/FX2s RACADM CommandLine Reference Guide available at dell.com/support/manuals.Configuring iDRAC VLAN tag settingsVLANs are used to allow multiple virtual LANs to co-exist on the same physical network cable and to segregate the network trafficfor security or load management purposes. When you enable the VLAN functionality, each network packet is assigned a VLAN tag.VLAN tags are chassis properties. They remain with the chassis even when a component is removed.77
