Installing Drives 10-19*HQHUDO3URFHGXUHIRU,QVWDOOLQJ6&6,'HYLFHVConfigure and install one or more SCSI devices in your computer as follows: 'HWHUPLQH ZKLFK FRQQHFWRU RQ WKH LQWHUQDO 6&6, FDEOH \RX ZLOO DWWDFK WRHDFK 6&6, GHYLFHSee “SCSI Configuration Guidelines” found earlier in this section. 8QSDFN HDFK 6&6, GHYLFH DQG SUHSDUH LW IRU LQVWDOODWLRQ&$87,216 *URXQG \RXUVHOI E\ WRXFKLQJ DQ XQSDLQWHG PHWDO VXUIDFHRQ WKH EDFN RI WKH FRPSXWHU:KHQ \RX XQSDFN WKH GULYH GR QRW VHW LW RQ D KDUG VXUIDFH ZKLFK PD\GDPDJH WKH GULYH ,QVWHDG VHW WKH GULYH RQ D VXUIDFH VXFK DV D IRDPSDG WKDW ZLOO VXIILFLHQWO\ FXVKLRQ LWConfigure the device for a SCSI ID number and disable termination, if necessary.For instructions, see the documentation that came with the SCSI device as wellas “SCSI Configuration Guidelines” found earlier in this section. ,QVWDOO WKH 6&6, GHYLFHV DV DSSURSULDWHáTo install a SCSI hard-disk drive, complete steps 3 through 9 of “Installing anEIDE Hard-Disk Drive in the Internal Hard-Disk Drive Cage” found earlier inthis chapter. Then continue with step 4 of this procedure.áTo install a SCSI tape drive, CD-ROM drive,or DAT drive, complete steps 2through 6 of “Installing a Drive in a 5.25-Inch Drive Bay” found earlier in thischapter. Then continue with step 4 of this procedure.áTo install an external SCSI device, continue with step 4 of this procedure.áIf you are installing a SCSI host adapter card, configure the card and install itin an empty expansion slot (see “Installing an Expansion Card” in Chapter 9.)If you attach any SCSI hard-disk drives to the host adapter card, connect thehard-disk drive access cable to the SCSI host adapter card and to the AUXLED connector on the system board (see Figure 9-1). $WWDFK WKH 6&6, FDEOH WR HDFK 6&6, GHYLFHFor additional instructions on connecting SCSI devices, see “SCSI Cables” foundearlier in this section.If you are installing an internal SCSI device, firmly press the SCSI cable’s headerconnector onto the 50- or 68-pin connector on the back of the device.&$87,21 WKH GULYH·V LQWHUIDFH FRQQHFWRU WR DYRLG SRVVLEOH GDPDJH WR \RXUV\VWHPThe connectors on Narrow SCSI cables are keyed for proper positioning—a raisedarea on the outside of the header connector fits into a notch on the device con-nector. The connectors on Wide SCSI cables are shaped so that they can beattached one way only.23205BK0.BK : 23205100.FM Page 19 Wednesday, March 18, 1998 1:51 PM