Adding and Replacing Parts 2514 Replace the computer cover (see "Replacing the Computer Cover" onpage 145).See the documentation that came with the drive for instructions oninstalling any software required for drive operation.Floppy DriveCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions in theProduct Information Guide.CAUTION: To guard against electrical shock, always unplug your computer fromthe electrical outlet before opening the cover.NOTICE: To prevent static damage to components inside your computer, dischargestatic electricity from your body before you touch any of your computer’s electroniccomponents. You can do so by touching an unpainted metal surface on thecomputer.NOTE: A floppy drive or Media Card Reader must be installed in the 3.5-inch drivecarrier in order to be installed in a drive bay.Removing a Floppy Drive1 Follow the procedures in "Before You Begin" on page 139.CAUTION: Your computer is heavy (it has an approximate minimum weight of 55lbs) and can be difficult to maneuver. Seek assistance before attempting to lift,move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoidinjury; avoid bending over while lifting. See yourProduct Information Guide forother important safety information.CAUTION: The computer stand should be installed at all times to ensuremaximum system stability. Failure to install the stand could result in the computertipping over, potentially resulting in bodily injury or damage to the computer.2 Remove the computer cover (see "Removing the Computer Cover" onpage 141).3 Remove the drive panel (see "Removing the Drive Panel" on page 246).4 Disconnect the power and data cables from the back of the floppy drive.5 Disconnect the other end of the drive cable from the system boardconnector labeled "DSKT." To locate system board connectors, see "SystemBoard Components" on page 27.