Photo menu The following Photo options will not time out after two minutes of inactivity or after youturn off the printer, but they will return to the factory default settings when a memorycard or flash drive is removed.• Photo Effects• Photo Size• Layout• QualityTo change the temporary settings into new default settings1 From the printer control panel, press .2 Press the arrow buttons to scroll to Defaults, and then press .3 Press the arrow buttons to scroll to Set Defaults, and then press .Use Current appears on the display.4 Press again to select Use Current.5 Press until you exit Setup, or press another mode button.To disable the settings timeout featureYou can disable the settings timeout feature if you do not want the printer to revert to the default settings after twominutes of inactivity or after the printer is turned off.1 From the printer control panel, press .2 Press the arrow buttons to scroll to Device Setup, and then press .3 Press the arrow buttons to scroll to Clear Settings Timeout, and then press .4 Press the arrow buttons to scroll to Never, and then press .5 Press until you exit Setup, or press another mode button.Changing the Power Saver timeoutThe Power Saver timeout is the time it takes for the printer to switch to Power Saver mode when the printer is leftidle. The Power Saver feature optimizes energy efficiency by reducing the printer power consumption (as much as28 percent on some printer models) compared to the default printer settings. To save the most energy, select thelowest Power Saver timeout.1 From the printer control panel, press .2 Press the arrow buttons to scroll to Device Setup, and then press .3 Press the arrow buttons to scroll to Power Saver, and then press .4 Press the arrow buttons to select a Power Saver timeout, and then press .5 Press until you exit Setup, or press another mode button.Using the printer control panel buttons and menus19
