EXEC PRIVELEGED mode.clear frrpViewing the FRRP ConfigurationTo view the configuration for the FRRP group, use the following command.• Show the configuration for this FRRP group.CONFIG-FRRP mode.show configurationViewing the FRRP InformationTo view general FRRP information, use one of the following commands.• Show the information for the identified FRRP group.EXEC or EXEC PRIVELEGED mode.show frrp ring-idRing ID: the range is from 1 to 255.• Show the state of all FRRP groups.EXEC or EXEC PRIVELEGED mode.show frrp summaryRing ID: the range is from 1 to 255.Troubleshooting FRRPTo troubleshoot FRRP, use the following information.Configuration Checks• Each Control Ring must use a unique VLAN ID.• Only two interfaces on a switch can be Members of the same control VLAN.• There can be only one Master node for any FRRP group.• You can configure FRRP on Layer 2 interfaces only.• Spanning Tree (if you enable it globally) must be disabled on both Primary and Secondary interfaceswhen you enable FRRP.– When the interface ceases to be a part of any FRRP process, if you enable Spanning Tree globally,also enable it explicitly for the interface.• The maximum number of rings allowed on a chassis is 255.Sample Configuration and TopologyThe following example shows a basic FRRP topology.Example of R1 MASTERinterface TenGigabitEthernet 1/24no ip address286 Force10 Resilient Ring Protocol (FRRP)
