• Specify whether some or all some of the interfaces are passive.CONF-IPV6-ROUTER-OSPF modepassive-interface {interface slot/port}Interface: identifies the specific interface that is passive.– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/portinformation.– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.– For a port channel interface, enter the keywords port-channel then a number.– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.To enable both receiving and sending routing updates, use the no passive-interface interfacecommand.To indicate that hello packets are not transmitted on that interface, when you configure a passiveinterface, the show ipv6 ospf interface command adds the words passive interface.Redistributing RoutesYou can add routes from other routing instances or protocols to the OSPFv3 process.With the redistribute command, you can include RIP, static, or directly connected routes in the OSPFprocess. Route redistribution is also supported between OSPF Routing process IDs.To add redistributing routes, use the following command.• Specify which routes are redistributed into the OSPF process.CONF-IPV6-ROUTER-OSPF moderedistribute {bgp | connected | static} [metric metric-value | metric-typetype-value] [route-map map-name] [tag tag-value]Configure the following required and optional parameters:– bgp | connected | static: enter one of the keywords to redistribute those routes.– metric metric-value: The range is from 0 to 4294967295.– metric-type metric-type: enter 1 for OSPFv3 external route type 1 OR 2 for OSPFv3 externalroute type 2.– route-map map-name: enter a name of a configured route map.– tag tag-value: The range is from 0 to 4294967295.Configuring a Default RouteTo generate a default external route into the OSPFv3 routing domain, configure Dell Networking OS.To specify the information for the default route, use the following command.• Specify the information for the default route.CONF-IPV6-ROUTER-OSPF modedefault-information originate [always [metric metric-value] [metric-typetype-value]] [route-map map-name]Configure the following required and optional parameters:580 Open Shortest Path First (OSPFv2 and OSPFv3)
