• Set the number of minutes and seconds. The default is 10 minutes on the console and 30 minuteson VTY. Disable EXEC time out by setting the time-out period to 0.LINE modeexec-timeout minutes [seconds]• Return to the default time-out values.LINE modeno exec-timeoutExample of Setting the Time Out Period for EXEC Privilege ModeThe following example shows how to set the time-out period and how to view the configuration usingthe show config command from LINE mode.Dell(conf)#line con 0Dell(config-line-console)#exec-timeout 0Dell(config-line-console)#show configline console 0exec-timeout 0 0Dell(config-line-console)#Using Telnet to get to Another Network DeviceTo telnet to another device, use the following commands.NOTE: The device allows 120 Telnet sessions per minute, allowing the login and logout of 10 Telnetsessions, 12 times in a minute. If the system reaches this non-practical limit, the Telnet service isstopped for 10 minutes. You can use console and SSH service to access the system duringdowntime.• Telnet to the peer RPM. You do not need to configure the management port on the peer RPM to beable to telnet to it.EXEC Privilege modetelnet-peer-rpm• Telnet to a device with an IPv4 or IPv6 address.EXEC Privilegetelnet [ip-address]If you do not enter an IP address, Dell Networking OS enters a Telnet dialog that prompts you for one.Enter an IPv4 address in dotted decimal format (A.B.C.D).Enter an IPv6 address in the format 0000:0000:0000:0000:0000:0000:0000:0000. Elision of zerosis supported.Example of the telnet Command for Device AccessDell# telnet 10.11.80.203Trying 10.11.80.203...Connected to 10.11.80.203.Exit character is '^]'.Login:Management 73
