– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/portinformation.– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.– For a port channel interface, enter the keywords port-channel then a number.– For a Null interface, enter the keyword null then the Null interface number.– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.Configuring Telnet with IPv6The Telnet client and server in Dell Networking OS supports IPv6 connections. You can establish a Telnetsession directly to the router using an IPv6 Telnet client, or you can initiate an IPv6 Telnet connectionfrom the router.• Enter the IPv6 Address for the device.EXEC mode or EXEC Privileged modetelnet ipv6 address– ipv6 address: x:x:x:x::x– mask: prefix length is from 0 to 128.NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, whereeach group is separated by a colon (:). Omitting zeros is accepted as described in Addressing.SNMP over IPv6You can configure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receiveSNMP notifications from a device running Dell Networking OS IPv6. The Dell Networking OS SNMP-server commands for IPv6 have been extended to support IPv6. For more information regarding SNMPcommands, refer to the SNMP and SYSLOG chapters in the Dell Networking OS Command Line InterfaceReference Guide.• snmp-server host• snmp-server user ipv6• snmp-server community ipv6• snmp-server community access-list-name ipv6• snmp-server group ipv6• snmp-server group access-list-name ipv6Showing IPv6 InformationView specific IPv6 configuration with the following commands.• List the IPv6 show options.EXEC mode or EXEC Privileged modeshow ipv6 ?Example of show ipv6 Command OptionsDell#show ipv6 ?accounting IPv6 accounting information394 IPv6 Routing
