Denon ADV-700 Operating Instructions Manual

Also see for ADV-700: Brochure & specs Operating instructions Operating instructions Service manual Service manual

27ENGLISHSubwoofer (SW FREQ.) frequency• For the subwoofer frequency at the speaker setting screen, setthe bass crossover frequency for playback from the subwoofer.• Select “80 Hz”, “120 Hz”, “180 Hz” or “240 Hz” (-6 dB foreach). Bass sound below these frequencies is played from thesubwoofer.(This is set to “120 Hz” by factory default.)Assignment of low frequencies• In the Dolby Digital, Dolby Pro Logic II, DTS, and virtual surroundmodes, the low frequency signals for channels whose speakersettings are set to “Small” are assigned to the subwoofer. Thelow frequencies of channels set to “Large” are played fromthose channels.(If set to “120 Hz”, channels set to “Small” play sounds of 120Hz and greater, while bass frequencies of under 120 Hz areplayed from the subwoofer.)• In surround modes other than the ones listed above, lowfrequencies below the frequency set at the subwoofer frequencysetting are played from the subwoofer regardless of whether thespeakers are set to “Large” or “Small”.• Set the subwoofer frequency according to the low frequencyplayback abilities of your speakers and subwoofer.Subwoofer mode• The subwoofer mode setting is only valid when “LARGE” is setfor the front speakers and “YES” is set for the subwoofer in the“SPEAKER CONFIGURATION” settings.• When the “LFE+MAIN” playback mode is selected, the lowfrequency signal range of channels set to “LARGE” are producedsimultaneously from those channels and the subwoofer channel.In this playback mode, the low frequency range expand moreuniformly through the room, but depending on the size and shapeof the room, interference may result in a decrease of the actualvolume of the low frequency range.• Selection of the “LFE ” play mode will play the low frequencysignal range of the channel selected with “LARGE” from thatchannel only. Therefore, the low frequency signal range that areplayed from the subwoofer channel are only the low frequencysignal range of LFE (only during Dolby Digital or DTS signalplayback) and the channel specified as “SMALL” in the setupmenu.• Select the play mode that provides bass reproduction with body.• When the subwoofer is set to “YES”, bass sound is output fromthe subwoofer regardless of the subwoofer mode setting insurround modes other than Dolby/DTS.