Denon ADV-700 Operating Instructions Manual

Also see for ADV-700: Brochure & specs Operating instructions Operating instructions Service manual Service manual

ENGLISH68Description of timer• The timer can be used to switch the power between the ON andSTANDBY (OFF) modes once every day at the same time.(Everyday timer)• The timer can be used to play DVDs, CDs or TUNER.Before setting the timer• Set the current time.Be careful to set the right time.Checking the timer settings• Use the same procedure as when setting the timer to check thetimer settings.q Press the TIMER/SET button for at least 2 seconds to set thetimer setting mode.w Now press the TIMER/SET button again repeatedly to displaythe timer start function, the start time and end times.e After the end time (minutes) is displayed, the timer standbysetting is displayed, and when the TIMER/SET button is pressedagain the display returns to as it was before the timer was set.Changing the timer settings• Reset the timer using the new settings.• The previous settings are cleared when they are replaced with thenew settings.Clearing the timer settings• With “Step 4 to 12” displayed, press the TIMER/SET button for atleast 2 seconds. All the timer settings are cleared.• Press the TIMER/SET button again for a least 2 seconds, thedisplay returns to as it was before the timer was set.Turning the timer off• Press the TIMER/SET button, and when “T.Stdby” is displayed,turn the FUNCTION/SELECT dial to select “OFF”. (The display’smark turns off.)If there is a power failure• If there is a power failure or if the power cord has been unplugged,the clock display flashes once the power comes back on, the clockresumes counting, and if the timer was set the timer operatesaccording to the clock. Be sure to correct the current time setting.(2) Everyday timer (3) Setting the Everyday timerExample: To listen to a CD from 12:35 p.m. to 12:56 p.m.1c 8 1:02:46DVD TONE2,3,5,7,9,11,13,151,164,6,8,10,12,141 Turn on the power• Load a CD into the main unit for thepurpose of timer play.ON / STANDBYMain unit• Perform this operation after setting the current time (steps 1 to 7on page 67).2 Press the TIMER/SET button for at least 2 seconds.• If the time is set, “EVERYDAY” is displayed.TIMER/SETMain unitEVERYDAY5 Press the TIMER/SET button.• The timer setting mode is set and the timer start timesetting can be made.TIMER/SETMain unitOn AM12:00Green3 Press the TIMER/SET button.• “Timer FUNC” is displayed.TIMER/SETMain unitTimer FUNC4 Setting the timer start function.Set the function to “DVD”.Timer DVDFUNCTION/SELECTMain unit✽ “SET TIME” is displayed when the time setting has notbeen made. Perform operations 3 to 7 of Page 67, thenperform the timer setting again