114Learning functionIf an AV component is not a DENON product, or if it cannot be operated via codes provided in the AVC-A1XV remote control’s internal presetmemory, or if its codes cannot be successfully learned by the AVC-A1XV remote control, then you should use the remote control that was suppliedwith that AV component to operate the component.RC-9953, 7231, 861 Press the power ON button and the OFF buttonsimultaneously.2 Press the “2” button to selectLearning setup.3 Press the Mode button for the component you want tolearned, then press the ENTER button.Learning is not possible for the AMP, ZONE2, ZONE3 andZONE4 modes.4 Buttons that allow learning will light. Press the button that youwish to be learned. The display will go off and the unit willenter the learning standby mode.5 Point the Remote control units directly at each other andpress and hold in the button on the other Remote control unitwhich you want to “learn”.6 “OK” appears on the Remote control unit’s display andlearning is completed.• Other keys can be “learned” by repeating steps 5 to 6.• “FAIL” appears on the Remote control unit’s display,repeating steps 4 to 6.7 The mode can be switched bypressing a mode selector button.The “Buttons that allow learning”display reappears and the learningstandby mode is set.Other remotecontrol unit8 To cancel the learning mode, press the power ON button andthe OFF button simultaneously again.• To cancel, press the power ON buttonand the OFF button simultaneously.CH SEL ENTER
