886-6. Setting the Video Setup for ZONE2[1] Video Convert Mode (ZONE2)• Select the video input signal to be output to the ZONE2 composit, S-Video and component monitor output terminals using the videoconversion function.Z 2 V i d e o M o d e* Z 2 V i d e o S e t u p1 Select “Video Setup” at the Zone Setup menu.Z 2 V i d e o S e t u p* Z o n e S e t u p2 Display the Video Setup screen.3 Select “Video Convert Mode”, then press theENTER button.Display the Video Convert Mode.CH SEL ENTER(Main unit) (Remote control unit)CH SEL ENTER(Main unit) (Remote control unit)(Main unit)CH SEL ENTER(Remote control unit)CH SEL ENTER(Main unit)(Remote control unit)D V D : A u t o* Z 2 V i d e o M o d e4 q Select the ZONE2 input source. w Select the mode as below.AUTO : When there are multiple input signals for the input sources selected at ZONE2, the input signal is detected and the inputsignal output to the ZONE2’s monitor output terminal is selected automatically, in the following order of priority:Component, S-Video, Composite.Component : The component video input signal is always selected.If there is no component input signal among the input sources selected at ZONE2, no video signals are output to theZONE2 component monitor output terminal.S-Video : The S-Video input signal is always selected.Video : The composite input signal is always selected.OFF : The convert function does not operate.The video signal of the input source selected at ZONE2 is only output to the ZONE2 video monitor output terminal.The S-Video signal selected at ZONE2 is only output to the ZONE2 S-Video monitor output terminal.AUTO Component S-video Video OFFThe details in each mode are as follows.CH SEL ENTER(Main unit) (Remote control unit)CH SEL ENTER(Main unit) (Remote control unit)
