128[2] Recording Dolby Digital and DTS multichannel sources• With this set it is possible to record Dolby Digital and DTS multichannel signals converted into 2-channel analog signals.• The recording signals are output to the TAPE and VCR output terminals.• Down-mixed analog signals converted into digital signals are output from the OPTICAL 3, 4 and 5 digital output terminals at this time.1 Press the ZONE3/4/REC SELECT button until “RECOUT✽✽✽✽” (ZONE3 ✽✽✽✽) appears on the display. Then select“RECOUT SOURCE”.2 Set the input mode according to the source to be played.3 Set the surround mode by pressing the DIRECT or STEREObutton.• The multichannel digital signals are down-mixed and outputto the TAPE and VCR output terminals.1 123or4 Set the recording mode.[3] Dolby Headphone recording• When RECOUT mode is set to “source”, with the AVC-A1XV it is possible to output signals encoded in the Dolby Headphone mode fromthe recording output terminal and record them on a separate recorder.1 The Dolby Headphone play mode is set when headphones areconnected to the PHONES jack during playback in theDOLBY/DTS surround mode.2 When this is done, signals encoded in the Dolby Headphonemode are automatically output from the recording outputterminals (analog and digital) and can be recorded.3 Select the parameters and set the desired mode, then record.(Refer to the ⁄0 SURROUND “Dolby Headphone” pages 140,141.)1NOTE:Do not disconnect the headphones during recording.(Main unit)(Main unit)(Main unit)(Main unit)RC-995323(Remote control unit)(Remote control unit) (Remote control unit)This function does not work when “5.2 ch / 5.3 ch” is set for theMAIN ZONE’s channel setup.
