694-4. Setting the 3D Y/C Separation• This setting sets the action detection sensitivity of the 3-dimensional Y/C separation at the time of the video signal up-conversion to S-Video.1 Select “3D Y/C Separation” at the Video Setupmenu.2 Display the 3D Y/C Separation screen.M o t i o n D e t : M I D* 3 D Y / C S e p .3 D Y / C S e p .* V i d e o S e t u pCH SEL ENTER(Main unit) (Remote control unit)CH SEL ENTER(Main unit) (Remote control unit)3 Select the setting.HIGH : This sets the action detection sensitivity to a high level. It suits video with fast action.MID : This is the standard setting. Usually, this setting is recommended.LOW : This sets the action detection sensitivity to a low level. It suits video with little action,such as still images, etc.CH SEL ENTER(Main unit) (Remote control unit)NOTES:• When the component video input signal is a resolution other than 480i/576i, this setting is invalid and the input video is output withoutchange.• The setting of the aspect ratio is valid when the resolution has been set to 1080i or 720p. When the video is output at another resolution,please set the aspect ratio at the TV side.• If the video input signal includes copyright protection data, the signal is output with a resolution of 480p or 576p, even if the resolutionis set to 1080i or 720p.4 Enter the setting.The Video Setup menu reappears.CH SEL ENTER(Main unit) (Remote control unit)5 Enter the setting.The Video Setup menu reappears.CH SEL ENTER(Main unit) (Remote control unit)
