643-5. Setting the IEEE1394 Assign• Assign the device connected by IEEE1394 cable to an input source. The power of the device to be assigned must be turned on ahead of time.12Select “IEEE1394 Assign” at the Audio Input Setupmenu.Display the IEEE1394 Assign screen.I E E E 1 3 9 4 A s s i g n* A u d i o I n S e t u pD V D - 3 9 1 0 - - -* I E E E 1 3 9 4 A s s i g nq Select the device to be assigned to theinput source.w Select the input source.34 Enter the setting.The Audio Input Setup menu reappears.If you do not wish to assign the device connected by IEEE1394 cable to an input source, the IEEE1394 input can be selected by turning theFUNCTION knob. In this case, the connection information is cleared when the power of the connected device or the AVC-A1XV is turned off,so the selection procedure must be performed again.D V D - 3 9 1 0 : D V D* I E E E 1 3 9 4 A s s i g nNOTES:• By default, if no device has been connected using an IEEE1394 cable in the past, “No Connection” is displayed.• “Connection Change” is displayed if there is a change in the IEEE1394 connection status while this screen is displayed.• If the model name cannot be acquired from the connected IEEE1394 device, “UNKNOWN” is displayed.• If an IEEE1394 device other than one for IEEE1394 audio playback is connected, “Not Play” is displayed and the input source cannot beassigned.CH SEL ENTER(Main unit) (Remote control unit)CH SEL ENTER(Main unit) (Remote control unit)CH SEL ENTER(Main unit) (Remote control unit)CH SEL ENTER(Main unit) (Remote control unit)CH SEL ENTER(Main unit) (Remote control unit)
