1353 Ajust the level of the selected speaker.• The adjustment range for the different channels is +12 dB to –12 dB in step of 0.5 dB.• The sound from the subwoofer can be completely cut by lowering the SW (subwoofer) settingone additional from –12 dB (setting it to “OFF”).CH SELENTER(Main unit) (Remote control unit)When the surround back speaker setting is set to “1spkr” for “2-1. Speaker Configuration” (pages 46, 47), this is set to “SB”.Fader function• This function makes it possible to lower the volume of the front channels (FL, C and FR) or the rear channels (SL, SR, SBL and SBR) together.Use it for example to adjust the balance of the sound from each position when multi-channel music sources are played.1 Press the ENTER button then select “Fader”.• When pressing the ENTER button, the channel switches in the ordershown below each time the ENTER button is pressed.2 Press the Cursor left button to reduce the volume of the front channels, theCursor right button to reduce the volume of the rear channels.The fader function does not affect the subwoofer channel.The channel whose channel level is adjusted lowest can be faded to –12 dBusing the fader function.If the channel levels are adjusted separately after adjusting the fader, the faderadjustment values are cleared, so adjust the fader again.11,2(Main unit)CH SELENTER(Remote control unit)CH SELENTER(Main unit)(Remote control unit)6 # :%%-9 (%%-9%%-9 (9%%-9:(%%-9 9(%%-9 <%%-9 9%%-9 9%%-9 %%-9: - ,:(( (RC-9951,216 # :%-9 (%%-9%-9 (9%%-9:(%-9 9(%%-9 <%%-9 9%%-9 9%%-9 %%-9: - ,:(( (Example: When “FRONT” is selectedCH SELENTER(Main unit)(Remote control unit)FADERSRASBLSLBSLASRBSBRFL C FR SWWhen the surround back speaker setting is set to “1spkr” for “2-1.Speaker Configuration” (pages 46, 47), this is set to “SB”.orCH SELENTER(Main unit)(Remote control unit)or
