527 Enter the setting.The Channel Level screen reappears.To cancel the settings, press the Cursor down button to select “Level Clear” and “Yes” on theChannel Level screen, then make the settings again. 6 . , . ,& $ NOTES:• When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer’s own volume control.• When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affectall surround modes. Consider this mode a Master Channel Level adjustment mode.• After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes andadjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode,your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels withineach surround mode. (See pages 134, 135)• You can adjust the channel levels for each of the following surround modes: PURE DIRECT/DIRECT, STEREO, DOLBY/DTS SURROUND,HOME THX CINEMA, 9CH STEREO, WIDE SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB, CLASSIC CONCERT, MONOMOVIE, VIDEO GAME and MATRIX.• When using either surround speakers A or B, or when using surround speakers A and B at the same time, be sure to adjust the balanceof playback levels between each channel for the various selections of “A or B” and “A and B”.6 a. When “Auto” mode is selected:Test tones are automatically emitted from each speaker.The test tones are emitted from each speaker in the following order,at 4-second intervals the first time and second time around, 2-second intervals the third time around and on: :-9%%-9:(%%-9 (%%-9 (9%%-9 9(%%-9 9%%-9 9%%-9 %%-9 <%%-9&Use the Cursor left and right buttons to adjust all the speakers to thesame volume.The volume can be adjusted between –12 dB and +12 dB in units of 0.5dB.b. When “Manual” mode is selected:Example: When the volume is set to –11.5 dBwhile the test tone is beingproduced from the Front LchspeakerFLSW1spkr2spkrsC FR SRASBLSLBSLASBSRBSBRWhen the surround back speaker setting is set to “1spkr” for “2-1.Speaker Configuration”, this is set to “SB”.F L : - 1 1 . 5 d BT e s t T o n e A u t oq Select the speaker. w Adjust all the speakers to the samevolume. :-9%%-9:(%%-9 (%%-9 (9%%-9 9(%%-9 9%%-9 9%%-9 %%-9 <%%-9$ Example: “Manual” mode is selected.F L : - 1 1 . 5 d BT e s t T o n e M a n u a lCH SELENTER(Main unit)(Remote control unit)CH SELENTER(Main unit) (Remote control unit)CH SELENTER(Main unit) (Remote control unit)CH SELENTER(Main unit) (Remote control unit)FlashingFlashing
