767 Enter the setting.The Video Setup Menu reappears.CH SELENTER(Main unit) (Remote control unit)Select the method for playing the audio signalsincluded in the HDMI input signal.Select “TV” or “AMP”.AMP : The audio signals are played accordingto the AVR-5805’s speaker systems.TV : The audio signals are played accordingto the number of playable channels onthe monitor TV connected to the AVR-5805’s HDMI monitor output terminal.(Main unit)CH SELENTER(Remote control unit)CH SELENTER(Main unit)(Remote control unit)5 75 '# 75 75 75# 5 D 75 75 $ %&)%A u d i o : A M P* H D M I / D V I I nSelect the input for the playback of signals whenthe audio signal of HDMI can not be reproduced.When the audio signal of HDMI has becomeunlocked, the unit automatically changes over tothe set connector (ANALOG or EXT. IN).1~3 correspond to each HDMI 1~3 input terminal.Select input signal (ANALOG or EXT. IN).(Main unit)CH SELENTER(Remote control unit)CH SELENTER(Main unit)(Remote control unit)6 75 '# 75 75 75# 5 D D 75 75 $ %&)%1 : A N A L O G* H D M I / D V I I n4-6. Setting the Audio Delay• When watching a DVD or other video source, the picture on the monitor may seem delayed with respect to the sound. In this case, adjust theaudio delay to delay the sound and synchronize it with the picture.• The audio delay setting is stored separately for each input source.1 )& #- . , 5 -#- / ,B' & , 75 '# "- 03 /, & 0 4#- "&Select “Audio Delay” at the Video Setup Menu.2 Display the Audio Delay screen.%)"- 0 * &J ,0 m s* A u d i o D e l a yA u d i o D e l a y* V i d e o S e t u pCH SELENTER(Main unit) (Remote control unit)CH SELENTER(Main unit) (Remote control unit)NOTE:• If a monitor is connected with an HDMI cablebut the monitor is not compatible with HDMIaudio signal playback, only the video signalsare output to the monitor from the AVR-5805(DVI mode).Use the STATUS button to check whichmode is set for outputting HDMI signalsfrom the AVR-5805 (HDMI and DVI modes).
