114ENGLISHOperating the main remote control unitn Using the macro function1 MACRO2 QUICK SELECT) Button Macro numberQUICK SELECT 1 MACRO-1QUICK SELECT 2 MACRO-2QUICK SELECT 3 MACRO-3n Resetting the macro function1 $ POWER ON ZONE/DEVICE ON $ 2 “SETUP” flashes twice on the remotecontrol unit.2 * ui $ )+0"4"- $ ENTER3 * ui $ )+ 0!- $ ENTER4 8 + N- $ ' QUICK SELECT ) “RESET” flashes four times on theremote control unit and the normaloperation mode is restored.Button Macro numberQUICK SELECT 1 MACRO-1QUICK SELECT 2 MACRO-2QUICK SELECT 3 MACRO-3Specifying the zone used with the mainremote control unitWhen the ZONE SELECT button is pressed, only the set zone can beoperated with the remote control unit.• The factory setting is “M234”.1 $ POWER ON ZONE/DEVICE ON $ 2 “SETUP” flashes twice on the remotecontrol unit.2 * ui $ )+ ! "9- $ ENTER3 * ui ENTER“SET” flashes four times on the remotecontrol unit and the normal operationmode is restored.Remote control unitdisplay Zone to be usedM MAIN ZONE onlyM2 MAIN ZONE /ZONE2M23MAIN ZONE /ZONE2 /ZONE3M234MAIN ZONE /ZONE2 /ZONE3 /ZONE4Setting the Remote IDWhen using multiple DENON AV receivers in the same room, makethis setting so that only the desired AV receiver operates.• The factory setting is “ID-1”.1 $ POWER ON ZONE/DEVICE ON $ 2 “SETUP” flashes twice on the remotecontrol unit.2 * ui $ ) +0% 6- $ ENTER3 * ui 6 ENTER“SET” flashes four times on the remotecontrol unit and the normal operationmode is restored.Remote control unitdisplay Remote IDID-1 1ID-2 2ID-3 3ID-4 4NOTEWhen you change the remote ID, make sure that the remotecontrol unit and the remote ID of the main unit are exactly the same(vpage 105).
