Denon AVR-A100 Owner's Manual

Also see for AirPlay AVR-4311CI: Addiction of new function Adición de una función nueva Brochure & specs Addendum sheet Owner's manual

Contents

11Basic version Advanced version InformationENGLISH Simple versionError messagesAn error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc.If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.NOTEBe sure to turn off the power before checking speaker connections.Examples Error details Measures %'(##)?.9."##%"-%#.#(4 ..!;@:9.!%"-<**A%.9.#)#'(##)"43)#*##(#%'(##)6.!; "<4 "$"#B@:9.!%"-• Correct measurement is not possible due toinappropriate subwoofer volume.• When using a subwoofer with built-inamplifi er (active type), use “SW LevelMatching” to adjust the subwoofer volume(vpage 11 “Subwoofer level error messageand how to adjust”).• When using a subwoofer without a built-inamplifi er, select “Skip”, and then pressENTER. $!.#"!#%## $"#B• The connected setup microphone is broken,or a device other than the supplied setupmicrophone is connected.• Not all speakers could be detected.• The front L speaker was not properlydetected.• Connect the included setup microphone tothe SETUP MIC jack of this unit.• Check the speaker connections. $!.'"#""##%"-%#:9."##.#($"#B• There is too much noise in the room foraccurate measurements to be made.• Speaker or subwoofer sound is too low foraccurate measurements to be made.• Either turn off any device generating noiseor move it away.• Perform again when the surroundings arequieter.• Check the speaker installation and thedirection in which the speakers are facing.• Adjust the subwoofer’s volume. &# #$!.$"#B• The displayed speaker could not be detected. • Check the connections of the displayedspeaker. &#: %$!.$"#B "• The displayed is connected with thepolarities reversed.• Check the polarities of the displayedspeaker.• For some speakers, this error message maybe displayed even if the speaker is properlyconnected. If you are sure the connection iscorrect, press ui to select “Skip”, thenpress ENTER.Remote control operationbuttonsMove the cursor(Up/Down/Left/Right) Confi rm the setting Return to previous menuSubwoofer level error message and how to adjustThe optimal level of each subwoofer channel for AudysseyAuto Setup measurement is 75 dB. During subwoofer levelmeasurement (“Set up speakers (Audyssey® Auto Setup),STEP2 Detection & Measurement ” (vpage 9), 6 – q), an errormessage is displayed when one level of subwoofers is outside the72 – 78 dB range. When using a subwoofer with built-in amplifi er(active type), adjust the subwoofer volume so that the subwooferlevel is within the 72 to 78 dB range.1 4 $ +489 . $ - ENTER %'(##)?.9."##%"-%#.#(4 ..!;@:9.!%"-<**A%.9.#)#'(##)"43)#*##(#%'(##)6.!; "<4#!*#'(##)9#.*A" $!. "$"#B@:9.!%"-