57Basic versionSimple version InformationENGLISH Advanced versionFront A/B connectionYou can connect a second set of speakers to this unit and use them for playback.To use a second set of speakers, select “Amp Assign” and set “Assign Mode” to “Front B” using steps3 and 4 of “Set up “Amp Assign”” (vpage 63).FL(A)FL(B) FR(B)FR(A)SWz You can also connect the Front B speakers to SURR.BACK/AMP ASSIGN or F.HEIGHT/AMP ASSIGNspeaker terminals using the “Amp Assign” and “Assign Sp.” settings (vpage 95).To perform multichannel playback, connect the center, surround, surround back, and front speakers, andsubwoofer.Front speakers can be used separately, depending on the speaker’s specifications or playback source suchas front speakers (A) for multichannel playback and front speakers (B) for 2-channel playback (vpage 98“Front Speaker Setup”).6.1-channel (Surround back speaker) connectionIf using only one surround back speaker (with a 6.1-channel connection), connect to the “L” side of theSURR. BACK/AMP ASSIGN terminal.For speaker settings in this case, see “When 6.1ch (Surround back speaker) installed” (vpage 55).To perform 6.1-channel playback using the surround back speakers, select “Amp Assign” and set “AssignMode” to “NORMAL” using steps 3 and 4 of “Set up “Amp Assign”” (vpage 63).Also use the “Speaker Config.” setting (vpage 95) to set “Surround Back” to “1 spkr”.FL FRCSBSL SRSWConnectFor speaker impedance and speaker cable connections, see page 5.
