Eaton 380 VCP-Wind Instructions For The Use, Operation And Maintenance

Contents

I.B. 70A2580H02 Page 33Effective November 2012Figure 6-16 Illustrative Testing Tape SampleFigure 6-17 Front View of CloSure TM Tool ShowingMounting/Testing Hole Locations (6352C49H01)Step 13 - Evaluate the CloSureTM” performance bycomparing the test tape with the illustrations in Figure 6-16. If the marking is similar to 6-1 6A, measure the overtravel “x”: If “x” is greater than or equal to 0.6 inches, thecircuit breaker performance is satisfactory. If “x” is lessthan 0.6 inches or if the marking is similar to 6-16B or 6-16C, contact your local Eaton sales representative ordistributor for service or go to www.EatonElectrical.comfor more Information about our products and support.Figure 6-18 Typical Circuit Breaker Front View withCloSure TM Tool Attached (approximate mechanismchassis width)BreakerLineApproximateMechanismCabinetWidth (inch)UpperMountingHoleLowerMountingHoleMarkerPlacementHoleVCP-Wind 33 A2 B2 C6Table 6.3 Closure TM Tool Mounting/Testing Locationsby Circuit Breaker TypeStep 14 - Remove the CloSure TM Tool. Reassemblethe front cover onto the circuit breaker. Return thecircuit breaker to its original configuration and setup.