Eaton COOPER POWER SERIES Installation And Operation Instruction Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Eaton COOPER POWER SERIES Installation And Operation Instruction Manual Manual pdf 36 page image

Installation procedure30 CBC-8000 capacitor bank control installation and operation instructions MN916001EN—October 2018 Eaton.comTo install the security sleeve:1. Open the CBC-8000 control door.2. Loosen the two thumb screws and open the front panel.3. On the bottom of the CBC-8000 control enclosure, markthe locations to drill each of the four holes required tomount the cable security sleeve.Note: The cable security sleeve must cover the cableconnectors and allow room for the temperaturesensor so that the sensor does not interfere with theinstallation.4. Using the 7/32 inch bit, carefully drill each of the fourholes.5. Align the studs on the cable security sleeve with theholes in the enclosure and confirm that the cablesecurity sleeve sits flush against the enclosure.6. The DIN cable or other cables will need to be routedthrough the cable security sleeve and connected to thecontrol before the cable security sleeve is permanentlymounted to the control.7. Route the cables through the cable security sleeve.8. Connect the DIN cable or other cables to the control.9. Slide the cable security sleeve over the cableconnections and bring it tight against the enclosure.10. Install a star washer onto each of the four studs for thecable security sleeve.11. Install a wing nut onto each of the four studs for thecable security sleeve and tighten.12. Close the front panel and tighten the two thumb screws.Storm trapper installationEaton recommends installing the optional Storm Trapper™High Energy (H.E.) low-voltage distribution-class MOV surgearrester between the line and the earth ground for the CBC-8000 control.The Eaton part numbers for the surge arresters that arerecommended for use with a CBC-8000 control are shown inTable 6Storm Trapper H.E. arresters are designed with a full 40 kAsurge withstand capability. This superior energy handlingability assures long service life even in the most severeservice conditions.Figure 34. Storm Trapper High Energy low-voltagedistribution-class MOV surge arresterAs shown in Figure 35, the surge arrester black lead isconnected to Line and the white lead is connected to EarthGround.Refer to the documentation provided with the storm trappersurge arrester for detailed installation instructions.Figure 35. CBC-8000 control storm trapper surge arresterwiring diagramTable 6. Storm trapper surge arrester part numbers.Eaton part number Line voltageASZH175C100 120 voltASZ350B1 240 voltLineNeutralLine NeutralStormTrapper MOVSurgeArresterCBC-8000 controlBlackwireWhitewireEarthGround