Eaton COOPER POWER SERIES Installation And Operation Instruction Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Eaton COOPER POWER SERIES Installation And Operation Instruction Manual Manual pdf 43 page image

Installation procedureCBC-8000 capacitor bank control installation and operation instructions MN916001EN—October 2018 Eaton.com 37Before placing the control into servicePrior to placing the control into service, the followinginstallation procedures must be properly completed andverified:Equipment misoperation.Do not connect the control to an energized capacitor bankuntil all control settings have been properly programmed andverified. Refer to the programming information for thiscontrol.Failure to comply can result in control and capacitor bankmisoperation, equipment damage, and personal injury. C1106.01. Verify that the control is properly mounted.2. Verify that the capacitor bank is installed according to alllocally approved standards and practices.3. Verify that AC disconnect switches are installed.4. Verify that the control and the neutral of the capacitorbank are properly grounded.Note: The CBC-8000 control is grounded through the groundlug located on the bottom of the control. This groundlug is not tied to the neutral side of the control’s inputpower (L2/N). Please make sure that the ground lug istied directly to Earth ground to ensure that the caseand internal components are safely grounded.5. Verify that the cable between the control and thecapacitor bank is properly connected and supported.6. Turn on the AC power to the control.Note: The control includes a feature that will turn off thebacklit LCD display after 5 minutes of inactivity at thefront panel (no buttons pressed). Pressing any buttonon the front panel will turn on the LCD displaybacklight.7. Verify that all of control programming parameters arecorrectly entered.Note: Refer to Service Information CBC-8000 capacitor bankcontrol ProView NXG application softwareprogramming guide (MN916002EN) for additionalinformation.8. Set the control clock to the correct time. The real-timeclock will maintain its time for approximately 3 dayswhen power is lost.Note: Refer to the CBC-8000 capacitor bank control ProViewNXG application software programming guide(MN916002EN) for additional information.