Eaton CROUSE-HINDS series Instruction Manual

Also see for Crouse-hinds series: Operating instructions Instruction manual Operating instructions Operating instructions Software manual

Contents

Eaton CROUSE-HINDS series Instruction Manual Manual pdf 48 page image

44INM MTL RugiCAM-IP Rev 518 4 If Wifi Switched Off Copper Network Connection AvailableIf the Enable WIFI is set to Off (default), as shown below, then the camera onlyenables the copper connection.If you are only using the copper connection, it is recommended to set the EnableWIFI to Off (default).18 5 Subnet Address Different For LAN And WifiSince only one of the LAN connections can be used at any time, it is recommendedthat the unused connection be setup to a different subnet address, as illustrated inNotes 2 and 3.18 6 Default Gateway OperationTo setup a device on a network with a fixed IP address requires a number ofparameters, one of these parameters is the default gateway.The default gateway is a network node that serves as a gateway (router) to anothernetwork (subnet), often involving not only a change of addressing, but also a differentnetworking technology.When the RugiCAM-IP wants to communicate with another device on a differentnetwork (subnet), it uses the Default Gateway device to route the IP messages ontoanother Router or one of the Routers local LAN connections.18 7 Changing From Copper LAN To Wifi (Or Vice Versa)When changing from copper LAN to Wi-Fi LAN the unit power should be cycled forthe new connection to be established.