Eaton CROUSE-HINDS series Instruction Manual

Also see for Crouse-hinds series: Operating instructions Instruction manual Operating instructions Operating instructions Software manual

Contents

Eaton CROUSE-HINDS series Instruction Manual Manual pdf 8 page image

4INM MTL RugiCAM-IP Rev 5• Additional led units can be daisy-chained - led connector x3 connects to x2 onnext led unit• The first LED units integral photo-resistive sensor allows the camera toautomatically switch to night mode (removes IR cut filter and setsmonochrome b/w mode) at low light levels, camera then switches on allconnected LED units. This depends on configuration to be set (section 5.4.5)using photo-resistive sensor mode.LED Unit(when used standalone - without camera)• With just a 12v supply connected LED unit lights up (~300mA). Applicationcould just switch the supply ON/OFF to control the light.• If a link is fitted between pin IN to OUT then the light ON/OFF is controlled byits internal light sensor• If control pin IN is driven high (2V - 5V) this turns the light OFF, driving low(0V) or open circuit this pin turns the light ON5 CONNECTING THE RUGICAM-IP TO A PC5 1 Internet Explorer1. Connect IS power to the camera from a suitable IS power supply such as MTL9492-PS-PLUS.2. Connect the RugiCAM-IP to a PC with Ethernet cable via an IS isolator, suchas MTL 9468-ET and power on the camera.NOTESOther Browsers are supported, they require an add on. For Chrome this can befound at www.ietab.net.Some older computers need a crossover cable if the NIC doesn’t have automaticcable switching3. On Windows 7, go to Control Panel\Network and Sharing Center; Click“Local Area Connection” and then click “Properties”. On Windows XP, goto Control Panel\Network and Internet\Network Connections. Right click onthe corresponding Network adapter and then click “Properties”.4. In Local Area Connection Properties, Click Internet Protocol Version 4(TCP/ IPv4) Properties.