Eaton PowerXL DF1 Series User Manual

945. Parameter DescriptionEaton Electric General Inverters DF1 Series UMXXXXXXXXE February 2020 www.eaton.comExample 3: This example is used by the industry for operating the ac motor drive. The goal is to have the set potenti-ometer equals to 10Hz when rotating to the far left. In other words, when activating, the lowest output of the ac motordrive has to be 10Hz. Other frequencies can be adjusted by the industry freely.Example 4: This example is also frequently used by the industry. The comprehensive usage for all domain of the potenti-ometer setup elevates the flexibility.Example 5: This example uses 0~5V to set the frequency.Example 6: This example is recommended to avoid using a signal that is less than 1V to set up the operation frequencyof the AC motor drive under an unfavorable application environment, so that the anti-noise interference effect will be bet-ter.60Hz P.38=60Hz Max operation frequencyP.192=0V, P.193=8.33V The minimum/maximuminput positive voltage of terminal 2-5P.194=16.7%, P.195=100% The settingcorresponding to the minimum/maximum positivevoltage of terminal 2-5P.510=16.7%, P.511=100% The settingcorresponding to the minimum/maximum negativevoltage of terminal 2-5P.512=0V, P.513=8.33V The minimum/maximuminput negative voltage of terminal 2-5P.194 = P.510 = 10Hz / 60Hz * 100P.193 = P.511 = 10V * (100.0 – P.194) / 10010V- 10V- 8. 33V 8. 33V10Hz0V60Hz10V- 10V10Hz0VP.38=60Hz Max operation frequencyP.192=0V, P.193=10V The minimum/maximuminput positive voltage of terminal 2-5P.194=16.7%, P.195=100% The settingcorresponding to the minimum/maximum positivevoltage of terminal 2-5P.510=16.7%, P.511=100% The settingcorresponding to the minimum/maximum negativevoltage of terminal 2-5P.512=0V, P.513=10V The minimum/maximuminput negative voltage of terminal 2-5P.139 = 0% The bias rate of 2-5 voltage signalP.194 = P.510 = 10Hz / 60Hz * 10060Hz5V- 5V30Hz0V 2. 5V- 2. 5VP.38=60Hz Max operation frequencyP.192=0V, P.193=5V The minimum/maximum inputpositive voltage of terminal 2-5P.194=0%, P.195=50% The setting corresponding to theminimum/maximum positive voltage of terminal 2-5P.510=0%, P.511=50% The setting corresponding to theminimum/maximum negative voltage of terminal 2-5P.512=0V, P.513=5V The minimum/maximum inputnegative voltage of terminal 2-5P.139 = 0% The bias rate of 2-5 voltage signal60Hz P.38=60Hz Max operation frequencyP.192=1V, P.193=10V The minimum/maximum inputpositive voltage of terminal 2-5P.194=0%, P.195=90% The setting corresponding to theminimum/maximum positive voltage of terminal 2-5P.510=0%, P.511=90% The setting corresponding to theminimum/maximum negative voltage of terminal 2-5P.512=1V, P.513=10V The minimum/maximum inputnegative voltage of terminal 2-5P.139 = 0% The bias rate of 2-5 voltage signalP.195 = P.511 = 100.0 – (1V / 10V) * 10010V- 10V54Hz1V- 1V