Eaton PowerXL DG1 Series VFD Quick Start Manual

Also see for PowerXL DG1 Series VFD: Communications manual Instruction leaflet Quick start guide

Contents

22Step 5 — Standard applicationPOWERXL DG1 SERIES ADJUSTABLE FREQUENCY DRIVES MN040012EN—December 2017 www.eaton.comTable 13. Digital output—P5, continuedCode Parameter Min. Min. Unit Default ID Note32 = FB Digital Input 233 = FB Digital Input 334 = FB Digital Input 436 = TC1 Status37 = TC2 Status38 = TC3 Status39 = In E-Stop40 = Power Limit Superv41 = Temp Limit Superv42 = Analog Input Superv51 = Motor Current 1 Supv52 = Motor Current 2 Supv53 = Second AI Limit Supv54 = DC Charge Switch Close55 = Preheat Active56 = Cold Weather Active note f58 = 2th Stage Ramp FrequencyActive59 = STO Fault60 = Run Bypass/Drive61 = Bypass OverloadP5.2 b RO1 Function 2 152 See Para ID 151P5.3 b RO2 Function 3 153 See Para ID 151P5.4 b RO3 Function 7 538 See Para ID 151P5.5 b Virtual RO1 Function 0 2465 See Para ID 151P5.6 b Virtual RO2 Function 0 2466 See Para ID 151P5.7 b Freq Limit 1 Supv 0 154 0 = No Limit1 = Low Limit Superv2 = High Limit SupervP5.8 b Freq Limit 1 Supv Val 0.00 See Para ID 102 Hz 0.00 155P5.9 b Freq Limit 2 Supv 0 157 0 = No Limit1 = Low Limit Superv2 = High Limit SupervP5.10 b Freq Limit 2 Supv Val 0.00 See Para ID 102 Hz 0.00 158P5.11 b Torque Limit Supv 0 159 0 = No Limit1 = Low Limit Superv2 = High Limit SupervP5.12 b Torque Limit Supv Val –300.0 300.0 % 100.0 160P5.13 b Ref Limit Supv 0 161 0 = No Limit1 = Low Limit Superv2 = High Limit SupervP5.14 b Ref Limit Supv Val 0.00 See Para ID 102 Hz 0.00 162P5.17 b Temp Limit Supv 0 165 See Para ID 161P5.18 b Temp Limit Supv Val –10.0 75.0 °C 40.0 166P5.19 b Power Limit Supv 0 167 See Para ID 161P5.20 b Power Limit Supv Val 0.0 200.0 % 0.0 168P5.21 b AI Supv Select 0 170 0 = AI11 = AI2P5.22 b AI Limit Supv 171P5.23 b AI Limit Supv Val 0.00 100.00 % 0.00 172P5.24 b RO1 On Delay 0 320 s 0 2111P5.25 b RO1 Off Delay 0 320 s 0 2112otes:N a Parameter value can only be changed after the drive has stopped.b Parameter value will be set to be default when changing macros.f Function is not available in FR7 and FR8 drives.