Eaton SC200 Operation Handbook

Also see for SC200: Installation and operation guide Installation and operation guide

CommunicationsCopyright © 2007-2011 Eaton Corporation. All Rights Reserved.IPN 997-00012-50H November 2011 91After this number of retries the SC200 will try the nextnumber in the Dial Out Numbers table. Dialing will stop if none of the numbers in the DialOut Number Table connect.Report Retry Interval: Set to the required interval between retries.Dial Out Number(s): Type the telephone number(s) to be called. Consult the modem documentation for appropriatedial modifiers.DCTools or PowerManagerII Communications Setup► To connect to the SC200 with DCTools or PowerManagerII:1 If not already installed, install the PC modem (hardware and software) according to themanufacturer's instructions.2 Install DCTools/PowerManagerII on the PC/laptop.3 Double-click the DCTools/PowerManagerII icon to open the Connection Manager window.4 Go to Connection > New to open a new connection dialog box.5 Enter:Connection Name: Comms Enabled: TrueProtocol: S3PConnect Using: Select the COM port used by the modem (if external) or themodem name.S3P Address: 0 (0 = Broadcast, 1-65279 = individual address)Phone Number: The number of the PSTN line used by the modem.Modem Logon: Clear if a logon script is not required for the modem.Select if a logon script is required. Click Logon Script to define.For more details, see DCTools/PowerManagerII online help(press F1).6 Press OK. DCTools/PowerManagerII will now connect to the SC200.7 See System Operation on page 21 for details of the SC200 control and monitoring functionsavailable via DCTools. For help using DCTools press F1.8 If required, access to the SC200 via DCTools or PowerManagerII can be password controlled.See Write Access Password on page 95.