Eaton SC300 Operation Handbook

Contents

CommunicationsCopyright © 2007-2018 Eaton Corporation. All Rights Reserved.IPN 997-00012-03 B2 Issue B2 July 2018 109Trap RepeatTrap Repeat RateEnable trap repeat if the network is not reliableenough to ensure that traps get through the first time.Enable Heartbeat TrapHeartbeat Trap PeriodThe heatbeat trap (if enabled) is sent periodically totell the NMS that the SC300 is still “alive” andcommunicating.For each SNMP trap receiver (up to 8) , configure the following parameters:Parameter Configuration GuidelinesName Type the name of the SNMP trap receiver (20 bytes maximum). This allows 20 ASCII characters, but less for languages with multi-bytecharacters.Level SNMP Trap Level – controls reporting of specific events for each receiver:• Select All Alarms And Warnings to receive Critical, Major and Minoralarms, and Warnings. (Typically Warnings are status messages suchas Equalize Active.)• Select Minor And Above to receive Critical, Major and Minor alarms.• Select Major And Above to receive only Critical and Major alarms.• Select Critical Only to receive only Critical alarms.• Select Disabled to disable notifications to the receiver. To prevent an SNMP Trap for an individual alarm, set Send Trap to Falsein the alarm's configuration.IP Address IP address of the trap receiver assigned by the network administrator.Port The default setting is 162. Do not change this setting, unless requested bythe network administrator.TrapCommunityA form of password used with SNMP V1 and V2c. Use public, unless thenetwork administrator has assigned a new password.Mode Select:• Normal Traps for sending traps to any network management system,except PowerManagerII• Acknowledged Summary Trap for sending traps to PowerManagerIIonlyTo change SNMP trap sending options by trap sourceTo make the SC300 send a trap only on an alarm activation or deactivation, or to stop the SC300sending any traps when a particular alarm occurs:1 Go to the Send Trap setting for that particular alarm. Send trap settings are present in the AlarmStates Table, Analog Input Alarms tables, and Digital input alarms table.2 Change the setting from Both to :• None for no traps sent of that alarm• Activation, for traps sent only when the alarm becomes active.• Deactivation, for traps sent only when the alarm becomes inactive.