System OperationCopyright © 2007-2018 Eaton Corporation. All Rights Reserved.IPN 997-00012-03 B2 Issue B2 July 2018 89Digital InputsThe Input / Output (I/O) board is fitted with a number of configurable digital inputs (DI) whichcan monitor external voltage-free relay contacts or switches. See Input / Output Board on page 3for details.► To configure a digital input1 On DCTools/web, go to Digital Inputs. Expand the Digital Inputs table. The number of digital inputs available for user digital inputs depends on the IO Board version.Refer to the I/O Board (IOBGP-xx) Connector Pin-outs on page 138 for IO Board input numbers. If additional I/O boards and/or SiteSure-3G modules are connected, there will be moreconfigurable Digital Inputs. See details in the dc power system Installation and Operation Guide.Some digital inputs are normally configured as Digital System States (see details on page 88).Only use these inputs if you do need need to use them as Digital System State Inputs.2 Select a configurable Digital Input.3 Configure the following parameters to suit the application. To change a setting, double-click and select from drop down list or edit the text.Parameter SettingStatus Set to Enabled.Name Type the name of the input.Function Set to User Defined.IOB Number The number of the I/O board (or SiteSure-3G module if connected). Do notchange.IOB DI Number The number of the DI on the I/O board (or SiteSure-3G module if connected).Do not change.Active State Select the state of the input that will activate the DI.Group Set to 0 unless using Groups in PowerManagerII. See PowerManagerII onlinehelp for details.
