SC300 Handbook14 Copyright © 2007-2018 Eaton Corporation. All Rights Reserved.IPN 997-00012-03 B2 Issue B2 July 2018Display Settings► To change the display contrast• Use the keypad to go to: Settings > Setup > Contrast > Edit.► To change the display language• See Language Options on page 21.► To change the display orientation (horizontal/vertical)Either:• Use the keypad to go to: Settings > Setup > Orientation > Edit.• Select the required orientation (vertical, horizontal-left or horizontal-right). Press Save.Or:• In Web go to: System > Interfaces> Physical Ports > Front Panel.• In DCTools, go to Configuration > Communications > Front Panel > Physical Mounting.• Select the required orientation (vertical, horizontal-left or horizontal-right). Click Apply. The functions of the navigations keys also change to suit the new display orientation.Main Screen ParametersThe parameters displayed on the SC300 main screen are configurable. Either two large or threesmall parameters can be displayed. The default settings are two large parameters with the valuesBus Voltage and Rectifier Current.1. Value 12. Value 2► To change the parameters displayed on the main screenEither:• Use the keypad to go to: Settings > Setup (tab) > Display Settings > Main ScreenLayout.Or:• In Web go to: System > Interfaces > Physical Ports > Front Panel.• In DCTools, go to Configuration > Communications > Front Panel.• Set Main Screen Layout to Two Large or Three Small.• Select the required parameters (see Note 1) for Value 1 and Value 2 (and Value 3 ifThree Small is selected).• For each of Value 1/2/3 Units, select No Units, e.g. Battery Temp. 25, With Value,e.g. Battery Temp. 25°C, or With Label, e.g. Battery Temp. (°C) 25.• If any of Analog Input, Energy Meter, Power Meter, Current Meter, Voltage Meter orSmart Analog are selected as a display parameter, then also select a value forValue 1/2/3 Index. See Note 2.
