Falcon 90 Professional Instructions For Use And Installation

Also see for 90 toledo: User guide

Contents

English37Conversion to anothergasServicing - warningThis conversion must be performedby a competent person. After conver-sion the installation must comply withthe relevant regulations and also thelocal electricity supply company re-quirements. Read the instructions be-fore converting this appliance.Failure to convert the appliance cor-rectly could invalidate any warranty orliability claims and lead to prosecu-tion.This instruction must be used in con-junction with the rest of the applianceinstruction, in particular for informa-tion on Standards, cooker positioning,connection hose suitability etc.When servicing or replacing gas-car-rying components disconnect fromgas before commencing operationand check appliance is gas sound af-ter completion.Do not use re-conditioned or unau-thorised gas controls.ConversionDisconnect from electricity and gasbefore servicing. Check appliance issafe when you have finished.This appliance is supplied as:-G 20 20millibarCAT II 2H3+CAT II 2E3+CAT II 2E3B/PCheck in the Technical Data sectionat the back of the book that thecooker is convertible to the gas youwant to use.InjectorsRemove burner caps and heads. Re-move old jets. Fit the new jets (seeTechnical Data section at the back ofthe book for correct jets). Reassem-ble in reverse order.Tap adjustmentCheck in the table at the back ofthe book to see if the bypassscrews need to be changed or ad-justed.Pull off all the control knobs.Open the oven door & grill door andremove the fixing screws underneaththe control panel. Some models havea plate under the control panel held inplace by the bottom fixing screws.Models with a handrailRemove the 2 handrail end-bracketfixing screws, remove the 2 cross-headed screws that were hidden bythe handrail end brackets.Lower facia panel clear of top retain-ing tags.Models without a handrailSlide the control panel to the right andthen pull forward.Take care not to damage or strain thewiring.To convert to other gases.Remove the bypass screw and fit thecorrect replacement.See table at the back of this book forcorrect size.Refit the control panel.Stick on labelStick the appropriate label on to thedata badge to indicate the gas the ap-pliance is now set for.Pressure TestingConnect the appliance to the gassupply. Check the appliance is gassound.See Technical data section at theback of this book for test pressures.The gas pressure can be measuredat one of the left hand hotplate burnerjets. Lift off a burner head. Fit thepressure gauge to the jet. Turn on thehotplate burner and turn on and lightone of the other burners.Reassemble burner top, making sureit is reassembled in the correct wayon the burner body.Check the appliance is gas sound.Check operation of all the burners.