GE ASTAT XL User Manual

ASTAT XL User Manual Fout! Stijl niet gedefinieerd.4 DET-8122 Caution StatementsCaution Statements cannot cover every potential cause of equipment damage but can highlightcommon causes of damage. It is the installer's responsibility to read and understand all instructionsin this manual prior to installing, operating or maintaining the equipment, to follow good electricalpractice including applying appropriate personal protective equipment and to seek advice beforeoperating this equipment in a manner other than as described in this manual.NOTEThe ASTAT XL soft starter is not user serviceable. The unit should only be serviced byauthorised service personnel. Unauthorised tampering with the unit will void the productwarranty.2.1 Electrical Shock RiskThe voltages present in the following locations can cause severe electric shock and may be lethal:• AC supply cables and connections• Output cables and connections• Many internal parts of the starter, and external option unitsThe AC supply must be disconnected from the starter using an approved isolation device before anycover is removed from the starter or before any servicing work is performed.WARNING - ELECTRICAL SHOCK HAZARDModels QLxxB0500D~QLxxX1600D: The busbar and heatsink must be treated as live wheneverthe unit has mains voltage connected (including when the starter is tripped or waiting for acommand).AVERTISSEMENT - DANGER D'ELECTROCUTIONModèles QLxxB0500D à QLxxX1600D : Les barres de puissance et le radiateur doivent être traitéscomme étant des éléments sous tension si l'appareil est relié au secteur (y compris lorsque ledémarreur s'est mis en sécurité ou s'il attend une commande).SHORT CIRCUITThe ASTAT XL is not short circuit proof. After severe overload or short circuit, the operation of theASTAT XL should be fully tested by an authorised service agent.GROUNDING AND BRANCH CIRCUIT PROTECTIONIt is the responsibility of the user or person installing the ASTAT XL to provide proper groundingand branch circuit protection according to local electrical safety codes.2.2 System Design and Safety of PersonnelThe starter is intended as a component for professional incorporation into complete equipment or asystem. If installed incorrectly, the starter may present a safety hazard.The starter uses high voltages and currents, carries stored electrical energy, and is used to controlequipment which can cause injury.Close attention is required to the electrical installation and the system design to avoid hazards either innormal operation or in the event of equipment malfunction. System design, installation, commissioningand maintenance must be carried out by personnel who have the necessary training and experience.They must read this safety information and this guide carefully.None of the starter functions must be used to ensure safety of personnel, ie they must not be usedfor safety-related functions.Careful consideration must be given to the functions of the starter which might result in a hazard,either through their intended behaviour or through incorrect operation due to a fault. In anyapplication where a malfunction of the starter or its control system could lead to or allow damage, lossor injury, a risk analysis must be carried out, and where necessary, further measures taken to reducethe risk.The system designer is responsible for ensuring that the complete system is safe and designedcorrectly according to the relevant safety standards.