GE ASTAT XL User Manual

ASTAT XL User Manual Fout! Stijl niet gedefinieerd.46 DET-812Description: Slows the ASTAT XL's response to current imbalance, avoiding trips due tomomentary fluctuations.5C – Undercurrent DelayRange: 0:00 - 4:00 (minutes:seconds) Default: 5 secondsDescription: Slows the ASTAT XL's response to undercurrent, avoiding trips due tomomentary fluctuations.5D – Instantaneous Overcurrent DelayRange: 0:00 - 1:00 (minutes:seconds) Default: 0 secondDescription: Slows the ASTAT XL's response to overcurrent, avoiding trips due tomomentary overcurrent events.5E – Input A Trip DelayRange: 0:00 - 4:00 (minutes:seconds) Default: 0 secondDescription: Sets a delay between the input activating and the soft starter tripping.5F – Input A Initial DelayRange: 00:00 - 30:00 (minutes:seconds) Default: 0 secondDescription: Sets a delay before an input trip can occur. The initial delay is counted fromthe time a start signal is received. The state of the input is ignored until theinitial delay has elapsed.5G – Frequency DelayRange: 0:01 - 4:00 (minutes:seconds) Default: 1 secondDescription: Slows the ASTAT XL's response to frequency disturbances, avoiding trips dueto momentary fluctuations.8.4.6 6 Inputs6A – Local/RemoteOptions: LCL/RMT Anytime HAND/AUTO button is always enabled.LCL/RMT When Off HAND/AUTO button is enabled when the starter is off.Local Control Only All remote inputs are disabled.Remote Control Only Local control buttons (START, RESET, HAND/AUTO) aredisabled.Description: Selects when the HAND/AUTO button can be used to switch between localand remote control, and enables or disables the local control buttons andremote control inputs.The STOP button on the keypad is always enabled.6B – Comms in RemoteOptions: Disable Control in RMTEnable Control in RMT (default)Description: Selects whether the starter will accept Start and Stop commands from theserial communication network when in Remote mode. The Reset andLocal/Remote Control commands are always enabled.6C – Remote Reset LogicOptions: Normally Closed (default)Normally OpenDescription: Selects whether the ASTAT XL's remote reset input (terminals 58, 57) isnormally open or normally closed.6D – Input A Function