GE AT600 User Manual

Also see for AquaTrans AT600: User manual

Contents

Chapter 4. Error Codes and Troubleshooting74 AT600 User’s Manual4.1.2c E3: Velocity RangeProblem: The velocity exceeds the limits programmed in the menu Program  Advanced  Error Limits VelocityLow/High;Cause: When the measured velocity is out of the limit of velocity, it will cause this error. The error may be causedby improper programming data, poor flow conditions and/or excessive turbulence;Action: Make sure the actual flow rate is within the programmed limits. Also, check the entered value in the menuProgram  Advanced  Error Limits Velocity Low/High. Refer to Diagnostics, to correct the flowcelland/or transducer problems.4.1.2d E4: Signal QualityProblem: The signal quality is outside the limits programmed in the menu Program  Advanced  Error LimitsCorrelation Peak.Cause: The peak of the upstream or downstream correlation signals has fallen below the correlation peak limit, asset in the menu Program  Advanced  Error Limits Correlation Peak. This may be caused by aflowcell or electrical problem.Action: Check for sources of electrical interference and verify the integrity of the electronics console bytemporarily substituting a test flowcell that is known to be good. Check the transducers and relocate them,if necessary. See Diagnostics, for instructions.4.1.2e E5: Amplitude ErrorProblem: The signal amplitude exceeds the limits programmed in the menu Program  Advanced  ErrorLimitsAmp Disc Min/Max;.Cause: Solid or liquid particulates may be present in the flowcell. Poor coupling for the clamp-on transducers.Action: Refer to Diagnostics, to correct any flowcell problems.4.1.2f E6: Cycle SkipProblem: The acceleration exceeds the limits programmed in the menu Program  Advanced  ErrorLimitsAcceleration.Cause: This condition is usually caused by poor flow conditions or improper transducer alignment.Action: Refer to Diagnostics, to correct any flowcell and/or transducer problems.