AquaTrans™ AT600 User’s Manual 9Chapter 1. General Installation Instructions1.8 Mounting the Clamp-on Fixture and Transducer System (cont.)From the information on the previous page and the documentation included with your AT600 flow metersystem, you should already know the following details about your installation:• Pipe Size• Transducer Model• Transducer Frequency• Number of Traverses• Calculated Transducer Spacing• Number of Clamp-On FixturesBased on the known information, proceed directly to one of the following sections in the next chapter forinstructions on installing your AT600 clamp-on fixture(s) and transducers on the pipe:Note: See the flowchart in Figure 9 on page 10 to assist in choosing the appropriate instructions for yourspecific configuration.• “Transducer Spacing = 32 to 250 mm or 50 to 320 mm, Traverses = 2, Fixtures = 1” on page 11• “Transducer Spacing = 320 to 940 mm, Traverses = 2, Fixtures = 2” on page 14• “Transducer Spacing = 0 to 250 mm or 0 to 320 mm, Traverses = 1, Fixtures = 2” on page 17• “Transducer Spacing >320 mm, Traverses = 1, Fixtures = 2” on page 19
