Chapter 3. Wiring the AT600 Electronics24 AquaTrans™ AT600 User’s Manual3.1 Making the Electrical Connections (cont.)For proper wiring, the power lines, transducer cable and I/O lines must be routed through the appropriatecable glands (see Figure 24 below). Also, refer to “Wiring Cable Specifications and Requirements” on page 177for the required cable specifications.IMPORTANT: Any unused cable glands must be plugged with the cable gland inserts provided with meter.Figure 24: Recommended Cable Gland UsageGLAND HOLE 5GLAND HOLE 4GLAND HOLE 2GLAND HOLE 1GLAND HOLE 3DETAIL BBCABLE GLAND HOLESHole Num. Feed-Through Cables1 Power Lines2 Digital Output B Cable LinesDigital Output C Cable LinesGate Input Cable Lines3 Service Modbus Cable LinesCustomer Modbus Cable Lines4 Analog Output A Cable Lines5 Transducer Cable Lines
