Chapter 4. Initial Setup and Programming72 AquaTrans™ AT600 User’s Manual4.7.4.2 Setting the Pipe Material (cont.)4.7.4.3 Setting the Pipe LiningPress [] again, and a screen similar to the following opens.Note: The units shown are the units selected in the Units Setting menu.Use the [] or [] key to select a specific digit, then use the [] or [] keyto change that digit as required. After all digits are correct, press [] tosave. Then, press [] to return to the previous screen.In the Pipe menu, select Lining and press [√]. The following screen opens.If there is no lining in your pipe, select No and press [√] to return to theprevious screen. If your pipe does have a lining, select Yes and press [√]twice. A screen similar to the following opens.To set the lining thickness, select Lining Thickness and press []. A screensimilar to the following opens.Pipe SOSPipe SOS2400.000 m/sPipe SOSUNIT: m/s2400.000]MOVE]UNDO [ ]SAVE ]]]MODF[PipePipe IDWall ThicknessPipe MaterialLiningLiningNoYesLiningLining ThicknessLining Material
