AquaTrans™ AT600 User’s Manual 73Chapter 4. Initial Setup and Programming4.7.4.3 Setting the Pipe Lining (cont.)Press [] again, and a screen similar to the following opens.Note: The units shown are the units selected in the Units Setting menu.Use the [] or [] key to select a specific digit, then use the [] or [] keyto change that digit as required. After all digits are correct, press [] tosave. Then, press [] to return to the previous screen.Select Lining Material and press [], then select the appropriate option andpress []. If your pipe material is not listed (see Table 4 below for theavailable options), select Other and press [√] twice. A screen similar to thefollowing opens.Table 4: Pre-Programmed Pipe Lining MaterialsName Lining MaterialTar Epoxy Tar EpoxyPyrex Glass Pyrex GlassAsbestos Cement Asbestos CementMortar MortarRubber RubberTeflon Teflon (PFTE)Lining ThicknessLining Thickness0.000 mmLining ThicknessUNIT: mm0.000]MOVE]UNDO [ ]SAVE ]]]MODF[Lining MaterialMORTRRUBBRREFLNOther
