AquaTrans™ AT600 User’s Manual 53Chapter 4. Initial Setup and ProgrammingSetting the Pulse ValueSetting the Pulse TimeUse the [] or [] arrow keys to select Pulse Value and press []. A screensimilar to the following opens.The Pulse Value is the amount of flow represented by one pulse in thedisplay. (e.g., 1 pulse = 10 m^3.) To change the existing setting, press []and a screen similar to the following opens.Note: The units shown are the units selected in the Units Setting menu.Use the [] or [] key to select a specific digit, then use the [] or [] keyto change that digit as required. After all digits are correct, press [] tosave. Then, press [] to return to the previous screen.Use the [] or [] arrow keys to select Pulse Time and press []. A screensimilar to the following opens.The Pulse Time (i.e., the pulse width) is displayed. To change the existingsetting, press [] and a screen similar to the following opens.Use the [] or [] key to select a specific digit, then use the [] or [] keyto change that digit as required. After all digits are correct, press [] tosave. Then, press [] to return to the previous screen.PulseMeasurementPulse ValuePulse TimeTest PulsePulse ValuePulse Value10.0000 m^3Pulse ValueUNIT: m^310.0000]MOVE]UNDO [ ]SAVE ]]]MODF[PulseMeasurementPulse ValuePulse TimeTest PulsePulse TimePulse Time5 msPulse TimeUNIT: ms5]MOVE]UNDO [ ]SAVE ]]]MODF[